|Post 1 made on Sunday August 12, 2018 at 16:45|
I'm an end-user who has a broken MLX-3 (off switch at the top is broken), and I just purchased a brand new MLX-3 from ebay to replace it. I was able to get it "acquired", however I have no clue how to extract a copy of the project from the broken remote and install it on the new/replacement remote. I could use a few pointers, please. Also note that I do not have access our CP3 or the code running on it.
|Post 2 made on Sunday August 12, 2018 at 16:48|
Without Crestron software, you can't do anything.
CEDIA University Designer CAT Team Member
CEDIA University Instructor
CEDIA Registered Outreach Instructor
|Post 3 made on Monday August 13, 2018 at 17:59|
I don't know about the MLX3 specifically, but you're probably not going to be able to retrieve what you need from an existing remote. You'll need the compiled UI file from the original integrator. Then you'll need the software (dealer only) in order to load it.
|Post 4 made on Tuesday August 14, 2018 at 12:52 |
You need the VTPro file for the remote and Crestron Toolbox to upload to the remote or gateway. It will need to be setup for the same RF ID as the broken remote. Without access to Toolbox and the compiled remote file, you're out of luck, it can't be extracted from the remote.
"Quality isn't expensive, it's Priceless!"
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.