|Post 1 made on Friday May 12, 2017 at 05:23|
I have programmed my amp using the example Crestron programme. All of the rooms are working apart from room 8. When clicking through the zones on the front panel zones 1-7 show as room 1 -7, however zone 8 displays as zone 8. I am not sure if this has any bearing. Any advice would be much appreciated.
|Post 2 made on Friday May 12, 2017 at 09:33|
Are you supplying the Room 1-7 names in Simpl?
When you send an input to Zone 8, what does the feedback say?
"Quality isn't expensive, it's Priceless!"
|Post 3 made on Friday May 12, 2017 at 14:04 |
Can you route audio and control zone 8 via toolbox and the sonex tool?
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.