| Post 1 made on Thursday December 22, 2016 at 14:49 |
installer1000 Lurking Member |
Joined:
Posts: | November 2016
3 |
|
|
I was reading a while back that it may be possible to use prodigy devices with other control processors. Upgrading from a PMC2 and wanted to see if anyone had success using a PAMP-4x100 with a PRO2?
|
|
| Post 2 made on Thursday December 22, 2016 at 14:53 |
kgossen Super Member |
Joined:
Posts: | March 2008
3,026 |
|
|
Pretty sure it's only 3 series processors that can do this.
|
"Quality isn't expensive, it's Priceless!" |
|
| Post 3 made on Thursday December 22, 2016 at 14:56 |
SWOInstaller Select Member |
Joined:
Posts: | October 2010
1,594 |
|
|
I had the same issue/question the other day. Not sure about a 2 series but you can control prodigy equipment with a 3 series. You need to ensure that the processor has the latest firmware, the prodigy equipment has the most up to date firmware and that your databases are up to date.
|
You can't fix stupid |
|
| Post 4 made on Thursday December 22, 2016 at 19:25 |
johnmax Long Time Member |
Joined:
Posts: | June 2004
187 |
|
|
I used a PAMP a couple years ago with a MC3 system (before Crestron freed up the restrictions on prodigy vs regular equipment). I just gave the PAMP the same Cresnet ID and programmed Simpl for a C2N-AMP4X100. Worked perfect. Not sure on a PRO2, but I think as long as the Cresnet IDs are the same it should work. Have done the same with Prodigy Mnet gateways too in Simpl.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
