| Post 1 made on Wednesday November 2, 2016 at 00:03 |
just4plaay Lurking Member |
Joined:
Posts: | December 2015
4 |
|
|
I have a DMPS running all of my A/V equipment that I programmed in Simpl. Recently I bought a PAC2M and a few CLX's for my basement finish. Using D3 I programmed the PAC2M and all of the lighting. D3 exports the RSD and if I open a new D3 program I can import it easily. However, if I go into my DMPS Simpl program I can't figure out how to import the RSD for my lighting program. Can someone please help.
My assumption was that I had to add a EISC to the correct IPID in Configure. Then go to Program, right click, and select "Import Remote System Def". The problem is that "Import Remote System Def" is not selectable so that's a no-go.
|
|
| OP | Post 2 made on Wednesday November 2, 2016 at 00:17 |
just4plaay Lurking Member |
Joined:
Posts: | December 2015
4 |
|
|
Apparently I'm working on this too late and my brain is turned off. Just had to go to Projects -> Import Remote System Definition
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
