Post 1 made on Tuesday December 23, 2014 at 15:27 |
five032 Lurking Member |
Joined: Posts: | December 2014 2 |
|
|
Hello:
I am new to crestron programming and I am trying to copy a previous ML 600 programming file to a new ML-600. Here is what I have done so far.
1) I have connected the ML 600 via RS 232 on my PC to the 1/8 jack on the ML-600 2) Went into Toolbox and selected Address book-->serial on COM1 -->Auto Detect-->"OK" Nothing happened.
I then went into SIMPL v 4.02 and choose Slot -09 RF Receiver for MT Series CNRGGWA-416 on the Pro 2 controller and selected RFID-30 which is the ML500/600 that I am trying to copy to the new remote.
When I select RFID-30 then choose "Transfer Program" I get the Address book choose Serial on COM1 again and hit OK.
After about 10 seconds I get the following error:
" --------------------------- Cannot transfer via Toolbox --------------------------- This device could not be found or may not yet be supported by Crestron Toolbox. Check that the device is connected and that you have the most recent update of the Crestron Toolbox application. Also, verify your settings in the Options->Crestron Toolbox Options-> Communications Settings to verify you are trying to connect to the proper device. If all else fails, you can try launching the Viewport application via the Legacy Device Support option on the Tools menu. "
When I try launching the Viewport it's grayed out. At this point I am not sure what to do. Can someone advise what I am doing wrong here.
Thanks in advance.
|
|
Post 2 made on Tuesday December 23, 2014 at 17:13 |
thecynic315 Senior Member |
Joined: Posts: | August 2008 1,001 |
|
|
1st-make sure your com port IS Com 1, if not change this
2nd-change Device Type :Auto Detect to ML-600
|
|
OP | Post 3 made on Wednesday December 24, 2014 at 09:37 |
five032 Lurking Member |
Joined: Posts: | December 2014 2 |
|
|
Thanks for the reply. I actually did both those things. I verified the COM 1 was selected and also tried selecting ML-600 from the dropdown list and I get the same error.
|
|
Post 4 made on Wednesday December 24, 2014 at 19:55 |
PeterN Active Member |
Joined: Posts: | July 2008 546 |
|
|
You can't load a SIMPL program to a remote. Use the VT-Pro file.
|
|
Post 5 made on Tuesday December 30, 2014 at 13:04 |
GotGame Super Member |
Joined: Posts: | February 2002 4,022 |
|
|
Why cant you use the old URC program to extract and install?
|
I may be schizophrenic, but at least I have each other. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.