Post 1 made on Sunday November 23, 2014 at 16:00 |
Drabert Long Time Member |
Joined: Posts: | October 2008 132 |
|
|
How in the world do you add these Crestron modules that you find on the net? I have the following files:
XXX.umc XXX.ush XXX.usp
I put the XXX.umc into my user module folder (defined in Simpl Editor)
I also put XXX.ush and XXX.usp into my Simpl+ module folder
but when I try to compile I get:
Check location in User SIMPL+ or program folder, or recompile the associated .USP file.
Can someone help me out and tell me where to put these files please?
Thank you
Eric
|
|
Post 2 made on Sunday November 23, 2014 at 16:45 |
kgossen Super Member |
Joined: Posts: | March 2008 3,026 |
|
|
You need to open up the .usp file in SIMPL+ and recompile. I've run into this a few times in the past and this always fixed the issue. When you recompile the .usp, it will create the proper .ush file.
|
"Quality isn't expensive, it's Priceless!" |
|
OP | Post 3 made on Sunday November 23, 2014 at 16:49 |
Drabert Long Time Member |
Joined: Posts: | October 2008 132 |
|
|
thank you for the response... where do you usually put your files? I recompiled and it is still giving me the error. I am not sure if I am placing this in the correct folder.
|
|
Post 4 made on Monday November 24, 2014 at 13:06 |
kgossen Super Member |
Joined: Posts: | March 2008 3,026 |
|
|
.umc in the Usrmacro folder along with any help pdf.
.ush and .usp in the Usrsplus folder.
You can change the folders and their location from within SIMPL.
|
"Quality isn't expensive, it's Priceless!" |
|
OP | Post 5 made on Wednesday December 3, 2014 at 12:06 |
Drabert Long Time Member |
Joined: Posts: | October 2008 132 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.