Post 1 made on Saturday April 7, 2012 at 17:57 |
cgav Select Member |
Joined: Posts: | September 2009 1,568 |
|
|
My post below about the compile errors is mainly due to this module. I can't seem to get it to be system builder friendly using the normal methods.
Anyone used the NX-587 with a System builder program before?
|
|
OP | Post 2 made on Saturday April 7, 2012 at 20:10 |
cgav Select Member |
Joined: Posts: | September 2009 1,568 |
|
|
Scratch that. Re-compiled the module with S+ it and it worked this time. Apparently I had an older, non systembuilder friendly module in the Macro directory so it was trying to use that. Only took me 24 hours to figure out and the client now thinks I'm a moron, but oh well.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.