Does anyone know if this can be setup in SystemBuilder yet? If not, i know this is asking a lot, but how hard is to get a processor connected to the service?

I signed up a few account names when it was first released, then went to setup my home account and found out that it can't be done in systembuilder and i don't want my accounts to expire.

thanks! 

I've done it with prodigy/system builder a couple of times with much help form tech support. If you have a pmc2+ you just drag the crestron software from their data base to the theatre room then fill the properties with the account name and software. You also have to add some dns entries into the processor then open ports. with a 3 series processor this is all done through your web browser menu.

The crestron ddns service takes a few hours to register so you won't instantly find out if your settings were correct.

Works great. I have done it with SB on adagio systems as well as Prodigy systems and PRO2. Just enter the account info into the properties menu and you should be good to go. When you log in with a x-panel or mobile pro remotely it will update Crestrons service and register.

So do you add the DNS client in SB like adding a device? I need to open SB and look around i guess.

 Okay, i found it and dropped into my program. Where i ender the domain name and password, do i leave the quotations and put the info between them or delete them?

where did you find it?

Just go to equipment and ADD EQUIPMENT to room, its under Crestron's list of devices.

that there is a bit but nothing I tried also, that the doors open on the router?
and what ip address
thanks