Fun with controlling a Vista 128 BPT over Crestron continues... I've gotten to the point where I can arm, disarm, etc the panel via the Crestron interface, but now I'm stuck on getting Zone Status to show. I have the modules from Crestron (v4.0), which include a Zone Status and Zone Decode module, but I'm honestly at a loss as to how to use them. I'm not at all familiar with SIMPL outside of changing a module to logic in order to use it in SB without using a physical output on the processor, but after that, I'm lost.

Any help would be greatly appreciated.

Thanks

Mike

I believe that this is a working problem. I had this same logic in a program and wasn't getting zone status. On that job, I actually did the old school keypad entering of everything that's on their PDF and it worked right away. Rc mail me your email address and I will send you a working program to look at.