Post 1 made on Monday May 30, 2011 at 20:03 |
audioandnetwork Long Time Member |
Joined: Posts: | November 2007 74 |
|
|
Hey Guys so i Went to a job today, its my first prodigy on System Builder, and I they have a Yamaha RX-A2000 wish can be controlled via IR, RS and IP, so I when to crestron modules and downloaded the RX-A3000 model, open on Simple, close simple and now y have it on System Builder. Now I had to drag it manually cause i dint put it on the Prodigy Composer and when i go to Properties on the Receiver I only have Serial or IR so System builder automatically assigns the Device to Slot 1 on COMN2-232, I dont mind if i have to do it via Serial, but I would like to Learn on do it via IP on System Builder, Thanks for any input on this!!!!
|
HELP NEEDED |
|
Post 2 made on Monday May 30, 2011 at 23:26 |
razking Long Time Member |
Joined: Posts: | February 2011 347 |
|
|
You likely only imported the serial module. I do not have access to my dev system right now. You might need to open it by dbl clk from windows explorer which will bring it into simpl. Make sure it gets saved into the usr mods directory. Then rebuild usr library.
|
You can't make toast in a floppy disk drive. www.envelopingsound.com |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.