I am new to this site and have about 6mo Crestron experience.
When connecting a Cen-Track to a functioning system all audio control gets finicky.  I have all the required firmware and the track is green but the cards have red X's.  I can control a few of the tuners but not all.  I have a error message of "Error: RemoveGatewayLink: node not found for socket from 192.168.1.51" with a following notice "Notice: Deleting Control System Gateway Socket from (192.168.1.51 - CIPId 0x3) due to peer program not ready/connection rejected" if I reference back to Crestron is states "internal system error contact Crestron".  Any suggestions would be much appreciated.

Thanks

BTW System Builder

Im going to go out on a limb and ask if you setup the IP Table on the CEN-TRACK and that the IPIDs are setup correctly.

I do everything in SIMPL so I dont know if SB uploads the IP Table to all the devices when you do a load.

Thanks Thecynic315 I believe I have the IP tables correctly. I have a Idoc running on the system the IP table set up is similar.

Make sure you set the IP table entry in the processor for the CEN-TRACK to the loopback address 127.0.0.1, if it is set to the IP address of CEN-TRACK, it will do what you are describing. I found this out recently when I updated the firmware of a CEN-TRACK and it stopped working.

Thanks Eastonaltreee,
I make my way thought that issue it is setup for the gateway loop back.
I have the Idock setup that way also with proper IPIDs for each.

Which is why I learned to code in Systembuilder. Systembuilder compiles into Simpl Windows and loads a spz into the processor. As with all .spz the IP Table is loaded into the processor. Systembuilder does not use Console commands to setup the iP table in the remote device. How could it? It has no idea what IP address the processor will be set. You have to setup the remote device manually just as when you use Simpl Windows.

Systembuilder does use scripts to load programs but that is about as much automation as it does.

Alan

If you are still having issues, then I would guess that your CEN-TRACK might have old firmware and is having the opposite problem I was describing. There is a brand spankin' new one available today that you might want to upload.

Did you get this resolved?

I am still having issues... I am going to spend the day on this until it s resolved.
Thanks for any help.