On April 16, 2011 at 09:26, Soundsgood said...
Already tried adjusting the repeat length, it just increases how much the volume goes up per press, 2db instead of 1db. How do I setup the volume commands as continuous?
You will need to have a learner. When you learn a given code, the learner gives you the option for pulse only or continuous. A menu pops up once the code has been learned.
Edit...you can also try going into deal under utilities and converting those commands from pulse only to pulse and hold. Again it may or may not work....
Whenever you make these changes, make sure you rebuild your database, delete the old device in your SB program and then add the new one. I always change the device name a bit in header details so that I remember which one is the new module.
Last edited by Gman-north on April 16, 2011 09:58.