Post 1 made on Wednesday February 16, 2011 at 22:48 |
cgav Select Member |
Joined: Posts: | September 2009 1,568 |
|
|
In the Sleep mode logic as built by composer/systembuilder automatically is under Receiver Device>2 Zone Volume Extender. I have a very out of the sanbox system I am working on. Normally I don't even leave sleep mode as an option for the client but this one specifically requested it. Where do I put in my extra IR/Serial codes to turn stuff off?
For example. I've got different rooms with TV's and surround receivers. A living room, a master bedroom, and a bonus room. If this client is in the living room and activates that PTX3's sleep mode, where do I put the commands to turn everything off that may be on? Would that go under the "Room_is_off" (rising edge) for living room?
|
|
Post 2 made on Thursday February 17, 2011 at 11:09 |
motech Super Member |
Joined: Posts: | August 2008 3,374 |
|
|
i could help you but im not good with system builder building everything for you. the way i do it is i have a macro that shuts off the entire system, i create 4 buttons on a sleep page , 30, 60, 90, 120, and put the all off macro on each button but with a delay before the macro...
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.