| Post 1 made on Sunday August 26, 2007 at 16:11 |
snappy Long Time Member |
Joined:
Posts: | September 2004
13 |
|
|
I have a multi-room system setup that has been running fine for a while now. MF-300 / mx-850 times 2 / RF-150
I have 5 devices currently one of them being a Comcast HD box all in the same cabinet. I decided to move the Comcast cable box from the other room into my main cabinet as well.
Problem now is that no matter how I program the mx-300 I cant get the remote to change channels on the two boxes indevidualy. Looking at the Flashers they all seem to fire when I send a command. Any command actually.
I thought that in setting the RF Device settings to:
Map Device to a specific Flasher number should work.
But it seems to ignore that. What am I doing wrong here. Any help would really be appreciated.
Thank you and have a great weekend.
|
|
| OP | Post 2 made on Sunday August 26, 2007 at 16:26 |
snappy Long Time Member |
Joined:
Posts: | September 2004
13 |
|
|
Problem Solved!!
It seems that when I upgraded to the MRF300 from the MRF250 that I did not change the default code "0" my mistake. Setting it to anything other than 0 seems to have done the trick..
|
|
| Post 3 made on Sunday August 26, 2007 at 16:54 |
OTAHD Super Member |
Joined:
Posts: | October 2005
4,679 |
|
|
Correct, you should set the base station to anything but 0 and then make the corresponding change in the software.
0 is only used to test for RF interference.
|
LET'S GO BUFFALO!!! |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
