| Post 1 made on Friday May 4, 2007 at 10:14 |
waffles Long Time Member |
Joined:
Posts: | April 2007
24 |
|
|
I am aware that a MSC400 can be extended with another MSC400. The same applies to a MRF300/350s. I was wondering if the MSC400 could be extended with a MRF300 or 350 for simple IR signal pass through.
TIA!
|
|
| Post 2 made on Friday May 4, 2007 at 14:36 |
KCThirstyEar Active Member |
Joined:
Posts: | January 2003
551 |
|
|
As far as actually extending it, no I don't think you can, since the two devices work very different from each other.
I'm not sure you'd gain anything by attempting to extend the 400 with the 300/350 anyway. You'd probably do just as well to set it up using a different RFID than your 400, and having two RFBS's assigned in your remote program. That'd do eveything you wanted it to.
|
KC
Audio Artisans |
|
| OP | Post 3 made on Sunday May 6, 2007 at 12:41 |
waffles Long Time Member |
Joined:
Posts: | April 2007
24 |
|
|
Thanks for your reply. All I want is to use the 400 to pass through the IR signal to the 350. This way it I could use the existing RFX-250 with a different base station. 6 IR ports on the 400 are just not enough for my application. If the 400 actually worked as advertised (and as promised by URC) this would be more of an academic point. However as far as I can tell the ports 7 to 14 are still not accessible for IR (see here : [Link: remotecentral.com])
|
|
| Post 4 made on Sunday May 6, 2007 at 22:09 |
ZMass Long Time Member |
Joined:
Posts: | September 2006
259 |
|
|
deleted. See the other post.
Last edited by ZMass
on May 6, 2007 22:28.
|
Zeke Mass
North County Home Theater |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
