On April 12, 2007 at 11:05, rioTejas said...
New mx900/mrf350 owner.
I'm only getting a range of two feet from my mx900 to
the rfx250. I've done the interference test at id#0 and
I see nothing on the status led unless i press a button
on the mx900. I switch back to id#1 and I only get status
at a range of two feet. This is with moving the mrf350/rfx250
out of the cabinet and just sitting on the chair. I've
tried with and without IR blasters connected. I've tried
adding the ferrite cores when I did have the blasters
connected.
The IR codes work great, just RF that is noop.
Did I get a bad unit?
Any Ideas?
Thanks in advance.
Have you adjusted the sensitivity on the RFX-250 with a screwdriver (ie. turned it all the way up)?