Post 1 made on Wednesday March 28, 2007 at 08:56 |
I hope this makes sense. I have a macro in a "system on" device which has codes from several "single component" devices. The emitters in the "component" devices are set to specific IR line #s. I assume I need to set my "system on" device emitter to ALL. My question is will this macro in the "system on" device send codes from each device to only the lines called out in the that "component" device or to all lines? Thanks
|
frass |
|
Post 2 made on Wednesday March 28, 2007 at 10:54 |
1ziggi1 Long Time Member |
Joined: Posts: | September 2006 410 |
|
|
The macro will call out the correct IR assignment associated to the correct device. So if the #1 unit is turned on first with an assignment of emitter #1 and #2 unit is assigned emitter #2 the maco will call out unit #1 IR #1 and then unit #2 IR #2 and so on.
|
|
OP | Post 3 made on Wednesday March 28, 2007 at 11:04 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.