Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
Dumb*ss wiring question?
This thread has 2 replies. Displaying all posts.
Post 1 made on Sunday April 18, 2021 at 12:44
Motorheadrules
Long Time Member
Joined:
Posts:
March 2018
10
I bought a new AV RCVR and it has a IR input connection on the back. I assume I can use an IR cable connected from the base station to the IR input instead of the using the sensors that stick the IR sensor (and never come off) on the front of the panel?

And the programming is the same- assign the rcvr to the base station port?

TIA!
Post 2 made on Monday April 19, 2021 at 00:18
FreddyFreeloader
Super Member
Joined:
Posts:
April 2004
3,243
Should work what brand? On a rare occasion the jack will be a stereo jack and you have to rig the pin-out, but it’s usually mono like the basestation IR output.
Post 3 made on Monday April 19, 2021 at 08:12
Duct Tape
Loyal Member
Joined:
Posts:
November 2008
5,295
sometimes those jacks are proprietary links that connect same branded equipment to each other.

assuming it is an ir input, then the codes will be the same as if you were using an emitter on the face of the unit.
[Link: facebook.com]


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse