| Post 1 made on Sunday October 18, 2020 at 11:43 |
TomatoBob Junior Member |
Joined:
Posts: | October 2020
6 |
|
|
I just purchased a used MX-890 which came with programming installed. I would like to copy this programming to CCP to use a a template for my new programming. When I go to communications/get from remote and select MX-980, I get an error message telling me "uploaded error, cannot connect".
Is there a way to get around this issue? I do not know if the existing programming was installed using CCP or the older software.
Any advice would be appreciated.
Thanks, Bob
|
|
| Post 2 made on Monday October 19, 2020 at 09:54 |
Duct Tape Loyal Member |
Joined:
Posts: | November 2008
5,297 |
|
|
Try choosing MX890. Not MX980. If the MX890 doesn't show up as an option, you may have an old version of CCP that can't be updated.
|
|
|
| Post 3 made on Saturday October 24, 2020 at 15:45 |
I had a similar issue . . . It appears that some remotes programmed either in much older versions, or with the standalone ediitors have programming that is incompatible with current CCP. They would seem to upload fine, hut then throw that error. Once a nee config was written, they ipload fine, so jothing wrong with comm or setip. Seen it both way for the same model, again, depending on what last programmed it.
And yes, it sucks . . .
|
|
| Post 4 made on Sunday October 25, 2020 at 15:09 |
Birstall Long Time Member |
Joined:
Posts: | September 2007
14 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
