Does anyone have discrete codes for HDMI1 & HDMI2 inputs on the mitsubishi DLP TV's??

Bump. Looking for them as well.
Art

if it is a new mitsu, do the following.

set the device select wsitch at the top to the tv position
press and hold the poer key unitl it flashes twice, then release the power key.
enter in wequence the code # 0,0,0,9,0. the power key will flash twice after the first 0 and then flash twice again after the final 0 to confirm a successful code enty.

the following keys will change function:
POWER=POWER ON ONLY
STOP=POWER OFF ONLY
INPUT FOLLOWED BY 1=INPUT 1
INPUT FOLLOWED BY 2=INPUT 2
INPUT FOLLOWED BY 3=INPUT 3
INPUT FOLLOWED BY 4=HDMI 2
INPUT FOLLOWED BY 5=COMP 1
INPUT FOLLOWED BY 6=COMP 2
INPUT FOLLOWED BY 7=COMP 3
INPUT FOLLOWED BY 8=ANT 2
INPUT FOLLOWED BY 9= ANT 1
INPUT FOLLOWED BY F1=HDMI 1
INPUT FOLLOWED BY F3=PC DVI-1 INPUT (NOT AVAILABLE FOR 731 SERIES )

REMEMBER WHEN YOU PRESS INPUT THIS PUTS THE REMOTE IS A STATE, IT DOES NOT GET LEARNED...

TO RETURN THE ORIG REMOTE BACK TO FACTORY SETTINGS:

SET THE DEVICE SELECT SWITCH AT THE TOP TO THE TV POSITION
PRESS AND HOLD THE POWER KEY UNITL IT FLASHES TWICE, THEN RELEASE THE POWER KEY.
ENTER IN SEQUENCE THE CODE # 0,0,9,3,5 THE POWER KEY WILL FLASH TWICE AFTER THE FIRST 0 AND THEN FLASH TWICE AGAIN AFTER THE FINAL 5 TO CONFIRM A SUCCESSFUL CODE ENTRY...

I FOUND THIS INFO ON THIS SITE, BUT DO NOT REMEMBER WHERE.

SO SORRY FOR MY BAD TYPING ...