Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
MX-890 "can't jump"
This thread has 1 response. Displaying all posts.
Post 1 made on Thursday September 12, 2019 at 22:06
RHahm
Lurking Member
Joined:
Posts:
September 2013
4
Hi,

MX-890

I recently added 2 new devices:

when I program the new buttons the "Jump To" function will not jump to the new device's first page at end of the macro. Instead the jump to line points to a different device ...

Yikes !

any help appreciated

CCP 3.9.0807.2

thanks in advance

rh
Post 2 made on Thursday September 12, 2019 at 23:23
edmund
Elite Member
Joined:
Posts:
April 2002
13,588
Look at macro box for other devices which do work, make sure the part that gets to first page of the device is same in the non-working devices. I used before and after macro, before gets you to the first page of the device, and after having delay making it push and hold macro for any other commands you wish on that key.

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse