Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
URC Remote TRC-1080 keeps delaying commands sent to Audio Video Equipments
This thread has 1 response. Displaying all posts.
Post 1 made on Friday May 10, 2019 at 06:56
blockfit
Junior Member
Joined:
Posts:
April 2019
13
I have my URC Remote TRC-1080 on 2.4Ghz connected to Ruckus Unleashed Wifi.

It works 80% of the time. Commands are quick and responsive, but sometimes the Remote delays the commands. I have to wait for the First command to be executed and then press the Remote Key for the next Command. This behavior is with all the remote commands.

I have tried switching the Wifi Channel from 1 to 11, doesn't help. The Wifi is dedicated to this remote. I have a static IP set for the Remote and the Wifi also has a static IP.

I have to Remove the battery from the Compartment and Reinstall the battery so that the Remote works Normal.

Does anyone have insight as to what could be going wrong here.

I am using Total Control 2.0, The Base Station is a MRX-15 with a Static IP
OP | Post 2 made on Friday May 10, 2019 at 06:59
blockfit
Junior Member
Joined:
Posts:
April 2019
13
One of the suggestions from a long time member is as follows:
-----------------------------------------------------------------------------------
This is how URC recommends you set up your TRC1080's wifi:

1. set the remote to dhcp and reserve the ip in your router
2. create a 2.4GHz only wifi network for the remote and connect to that
3. use channel 1,6, or 11
4. set channelization to 20
5. use WPA2 Only/AES for encryption
6. don't put any spaces in your SSID

----------------------------------------------------------------------------------------

I have configured as per above, but the lag in the commands from the TRC-1080 do occur sometimes and I have to remove the battery, wait for a few seconds and then reinstall the battery and then the remote starts working fine.

Does anyone have any idea how to troubleshoot this.

Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse