| Post 1 made on Friday April 5, 2019 at 16:00 |
Hi All, I'm dealing with an MX-900 that is not displaying any text at all. The screen lights up and the buttons beep when I press them but no text shows up. I have tried both the "loader" procedure (mute+on and batteries in) and the restore to factory settings procedure (Listen+Enter for 5 seconds and then LCD button 4, then LCD button 5 and LCD button 5 again) but no text shows during any of this steps. Anybody have run into this before?
|
|
| Post 2 made on Saturday April 6, 2019 at 11:06 |
tomciara Loyal Member |
Joined:
Posts: | May 2002
7,962 |
|
|
Sounds like a bad screen, not some bad program.
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
| Post 3 made on Sunday April 7, 2019 at 12:12 |
Daniel Tonks Wrangler of Remotes |
Joined:
Posts: | October 1998
28,780 |
|
|
Might want to try pulling it apart and see if the display ribbon cable is seated properly.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
