On April 7, 2018 at 19:56, goldenzrule said...
Ok. Good news. It works. It did not at first so I think you probably encountered the same issue. What I found out is that the PIR-1 firmware will update when connected to CCP, and then will update firmware when connected to Accelerator. I plugged in the PIR-1 first, then opened CCP and tried to learn. It did not work. I unplugged the PIR-1 and plugged back in and still did not work. I then closed CCP and unplugged the PIR-1. I started CCP and THEN plugged in the PIR-1. It didn't do anything at this time. When I went to learn a code, it updated the firmeware and then was able to learn. I tested the learned code via the PIR-1 and it worked.
I'd suggest doing what I did and start CCP first, then connect the PIR-1 and then try to learn a code to see if your firmware updates.
Thank you very much for testing!!!!
I tried the steps you mentioned several different times on my laptop and desktop PC both running Windows 10 without luck. I tried with the PIR-1 beeper on / off, with / without batteries, different USB cables.
When I try to learn, I get the message "Unsupported Operation was Attempted". If I click on Learn again, I get the message "Learn Status Check Error. Remote has disconnected." Perhaps my PIR-1 is defective. Any other thoughts / suggestions?
Was there a dialog box saying that the firmware was updating? I also tried updating CCP with the PIR-1 plugged in but that didn't do anything as I already run the lastest version of CCP.