Post 1 made on Tuesday January 16, 2018 at 13:03 |
ch8 Long Time Member |
Joined: Posts: | January 2014 21 |
|
|
Hi All,
Looking for some assistance on IP commands with complete control.
I am working with a setup in which the client has a z-wave system handled by a Vera home controller and . I have the light dimmers/switches and power outlets working with the remotes in the home using IP commands in complete control.
An example of the code for turning one of the lights on and off is
GET\x20/data_request?id=lu_action&output_format=xml&DeviceNum=115&serviceId=urn:upnp-org:serviceId:SwitchPower1&action=SetTarget&newTargetValue=1\x20HTTP/1.1\x0D\x0AContent-Length:\x200\x0D\x0A\x0D\x0A
The one device I am having issues with and need help on is getting the alarm system (which is integrated into the Vera control system). If it is of any help the device ID or devicenum for the alarm in Vera is devicenum52.
Does anyone have any input on how to make it work to arm and disarm the alarm?
Thanks
|
|
OP | Post 2 made on Wednesday January 17, 2018 at 14:55 |
ch8 Long Time Member |
Joined: Posts: | January 2014 21 |
|
|
nobody
Last edited by ch8 on January 23, 2018 12:36.
|
|
OP | Post 3 made on Tuesday January 23, 2018 at 12:37 |
ch8 Long Time Member |
Joined: Posts: | January 2014 21 |
|
|
Just trying to see if anyone here has any input /advice/help at all. I would think someone here would have some idea of how to get an alarm to arm/disarm using the code I pasted above.
|
|
Post 4 made on Wednesday January 24, 2018 at 11:15 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,299 |
|
|
post this in the RS232/IP Control section and you may get a response.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.