Post 1 made on Tuesday June 6, 2017 at 19:37 |
I'm using windows 10 and had previously install windows mobile device center and it worked with CCP. I started to notice the I would have to unplug and plug in again the remote to get it recognized. Now it doesn't work at all. Any advice would be appreciated.
2nd problem I'm having is my MX-980 and MRF-350 doesn't turn my Sony XBR 940D on when all the equipment turns on from an all off state. I have an emitter on the sony from the MRF-350. It will follow single commands after all the equipment is turned on with my "turn all on macro" for watching tv. The emitter is set to flash for all equipment commands. Is it over-saturating the IR receiver on TV? BTW everything worked till I did a firmware update on the Sony TV.
|
|
OP | Post 2 made on Thursday June 8, 2017 at 17:41 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.