Post 1 made on Tuesday December 13, 2016 at 13:13 |
Montythelab Lurking Member |
Joined: Posts: | September 2016 8 |
|
|
Hello, This week, my MX880 (using RF) seems to not function well in regards to all my programmed favorites for Xfinity Channels. For years, everything has been working fine...The buttons are not over-used and/or worn out like you would think volume or power buttons would be.
Was there a new Xfinity update that might be screwing me up? Anyone else have an issue like this?
If the channel favorite is '837 + enter' it might just show an 8. Now technically it doesn't even do that. Even when I stand right in front of AV equipment.
....Yet, I can type 8, 3, 7 on the number pad when I am across the room and it works perfectly...Seems odd.
|
|
OP | Post 2 made on Tuesday December 13, 2016 at 13:51 |
Montythelab Lurking Member |
Joined: Posts: | September 2016 8 |
|
|
Ignore this question...I just had some outdated codes that apparently worked up to this point.
I am reprogramming the favs and they appear to be working fine now.
Thanks.
I am still trying to figure out the last couple of button codes on the Samsung Smart remote that I bought a few mos ago. I cannot learn from it and I cannot locate the code I need. :(
|
|
Post 3 made on Wednesday December 14, 2016 at 10:28 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,295 |
|
|
make sure you add a short delay between the commands. usually .1 or .2 seconds is enough between each command. otherwise the remote sends them out too fast and the box usually won't keep up.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.