Post 1 made on Tuesday November 22, 2016 at 13:06 |
lawsondl Lurking Member |
Joined: Posts: | August 2006 8 |
|
|
I picked up a MSC-400 and was playing with the CCP software a bit, but ran into a question for the experts here.
When setting up a new serial device not in the database, I can't seem to find the actual port settings beyond designating Port# on the MSC. Where do the baud rate, stop bit, parity, etc get set up at? I'm not connected to it at this point, so does that happen during download or elsewhere?
Otherwise are those serial ports fixed at 9600 or something. I just can't find anything online or in the manual.
Thanks in advance of the holidays!
|
|
OP | Post 2 made on Tuesday November 22, 2016 at 13:21 |
lawsondl Lurking Member |
Joined: Posts: | August 2006 8 |
|
|
Ah, never mind, found a thread here that mentioned clicking on the port and editing the properties window. That was it.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.