| Post 1 made on Sunday November 20, 2016 at 15:34 |
mitch236 Long Time Member |
Joined:
Posts: | December 2006
38 |
|
|
Hi. I have tried on two separate MSC's that I've previously programmed using the same Fujitsu notebook with Windows XP but since I updated my URC program, I can no longer upload new programs. I keep getting the error "The MSC Basestation was not connected to USB!". I've tried multiple computers and USB cables. I even tried a computer that has never been used for programming. I installed the URC software and when I plugged in the USB cable, Windows told me that it installed the drivers needed for the USB and that it was connected successfully. I really need to get this project finished! I can communicate with all the other hand held remotes in the project (4 in total). There are 2 MSC basestations and I can't communicate with either one.
Help please!!
|
|
| Post 2 made on Sunday November 20, 2016 at 15:56 |
kgossen Super Member |
Joined:
Posts: | March 2008
3,026 |
|
|
Never had a problem with a 400 and XP. Luckily was smart enough to move my clients away when URC stopped supporting the 400 on anything but 32bit.
|
"Quality isn't expensive, it's Priceless!" |
|
| OP | Post 3 made on Sunday November 20, 2016 at 16:28 |
mitch236 Long Time Member |
Joined:
Posts: | December 2006
38 |
|
|
Never mind! I was using the front USB connector when I should have been using the rear! All is well again!
|
|
| Post 4 made on Monday November 21, 2016 at 13:18 |
Duct Tape Loyal Member |
Joined:
Posts: | November 2008
5,298 |
|
|
the front usb is the programming port, the rear usb is a keyboard emulator to control a pc.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
