Post 1 made on Sunday October 23, 2016 at 15:24 |
richiepleasericj Lurking Member |
Joined: Posts: | October 2016 1 |
|
|
Hey everyone. I'm having a strange issue after updating my msc400. I reprogrammed from scratch, and now when i try and run a trigger on my mx900, nothing turns on. the ir leds flash. when i have my rfx-250 plugged in, the status light flickers when im not running a macro. there's no rf interference. however, If i run a test on the msc400, everything works as should and turns on.
|
|
Post 2 made on Sunday October 23, 2016 at 16:40 |
kgossen Super Member |
Joined: Posts: | March 2008 3,026 |
|
|
If the status light on the 250 is flickering, you have RF interference. It should only light up when it's receiving a command from the remote. Try moving the 250 until the flickering stops.
|
"Quality isn't expensive, it's Priceless!" |
|
Post 3 made on Sunday October 23, 2016 at 18:29 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,298 |
|
|
check the rfx250 wiring, you might have your wires crossed. it is easy to do since the plugs are labeled differently at each end.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.