Post 1 made on Thursday March 24, 2016 at 05:06 |
I have a URC 850 with a 260 base and am trying to control a Directv new 4k client C61K. The URC controls all equipment correctly except the C61K. The URC can only manipulate two commands once the Directv device is selected from the URC. The Directv remote works perfectly and the C61K is in the IR mode(not RF). I am confused as to why a couple of commands work initially but after that no commands work. Anyone experienced this or have any suggestions?
|
|
Post 2 made on Thursday March 24, 2016 at 10:00 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,298 |
|
|
try using the SAT codeset 173
|
|
|
OP | Post 3 made on Thursday March 24, 2016 at 11:29 |
will try that. thx Duct Tape
|
|
OP | Post 4 made on Friday March 25, 2016 at 01:12 |
code set 173 worked, all codes working good. I had the wrong code set. thx again Duct Tape
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.