Post 1 made on Sunday November 22, 2015 at 11:11 |
Kremlar Long Time Member |
Joined: Posts: | February 2009 22 |
|
|
Is there a trick to getting the front blaster on the MRF-260 working? The manual indicates a setting in the software to enable/disable the blaster, but I'm using CCP and do not see a setting to control this.
I have my device setup in CCP to output RF to Blaster1 but I'm getting nothing out of the front blaster. If I hook an IR emitter to the MRF-260 and assign the device to that emitter it works fine.
I've tried a couple different devices with the same results, so I don't believe the front blaster is working.
Is there a way in CCP to enable/disable the front blaster? Any suggestions?
Thanks!
|
|
OP | Post 2 made on Sunday November 22, 2015 at 21:04 |
Kremlar Long Time Member |
Joined: Posts: | February 2009 22 |
|
|
DOH! Never mind. RF ID was still 0. Apparently it does not work on 0.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.