| Post 1 made on Monday November 16, 2015 at 09:49 |
hi guys,
running windows 7 using parallels 9 on my macbook pro 2014 and I'm unable to get the mx900 to connect or even show up on external devices, but the mx 900i connects no problem.
Any ideas?
thx
|
|
| Post 2 made on Wednesday November 18, 2015 at 10:31 |
tomciara Loyal Member |
Joined:
Posts: | May 2002
7,965 |
|
|
I don't have experience with Mac, but since you were talking about two different remotes, this is what I have seen once or twice. If one of the remotes has very old firmware, you may have to open up it's program in the standalone editor, then save it in the standalone editor. Then it can be imported into CCP successfully.. Hope that helps.
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
| Post 3 made on Thursday November 19, 2015 at 08:45 |
ShaferCustoms Long Time Member |
Joined:
Posts: | March 2014
380 |
|
|
Try using an external powered USB hub.
Shut down parallels
Plug in USB hub
Plug remote into hub
Fire up parallels
It works for Fusion when I run into older remotes.
Seems almost any mx900 two/three years and old will not connect directly. Some will not connect at all.
|
|
| OP | Post 4 made on Thursday November 19, 2015 at 15:14 |
Ok will try many thanks.
thank you
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
