Post 1 made on Friday July 24, 2015 at 17:44 |
BizarroTerl Active Member |
Joined: Posts: | October 2002 591 |
|
|
I have a MX-5000/MRX-1 combo. When I press a button several times fast the remote/controller doesn't keep up. I end up having to slow down my presses or just hold it which then repeats which in many cases is just too fast.
Am I hitting the hardware limits or is there a way to manage this in CCP? On the other end, is there a way to slow down the repeat speed (global is better than by individual key)?
|
|
Post 2 made on Friday July 31, 2015 at 19:10 |
tomciara Loyal Member |
Joined: Posts: | May 2002 7,958 |
|
|
IR, MRF, IP?
Most of mine are using a MRF350 and all good.
If you are trying to go thru an MRX, I would expect lags. I abandoned that trial.
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
OP | Post 3 made on Sunday August 2, 2015 at 17:32 |
BizarroTerl Active Member |
Joined: Posts: | October 2002 591 |
|
|
I set it up to use IP and it is much more responsive that it was using IR through a MRX-1 or MSC-400.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.