Post 1 made on Tuesday April 21, 2015 at 20:26 |
mitsu Long Time Member |
Joined: Posts: | March 2003 105 |
|
|
I want to make ups some custom length Vid6 video sensor cables for the MSC-400. Can anyone tell me what the pin out configuration is for these? On another thread I did see someone provided the below info however it either does not seem to work or I'm doing something wrong. I am connecting ring 2 to the RCA center pin and ring 4 to the RCA outer. Somehow I think the tip plays a role here somewhere. Thanks!!
Tip: Voltage Trigger Output Ring 2: 5VDC Power Input Ring 3: NC (Not connected) Ring 4: Ground
|
|
Post 2 made on Tuesday April 21, 2015 at 20:57 |
AVGregg Long Time Member |
Joined: Posts: | June 2006 314 |
|
|
Take existing URC Vid sensor cable, cut wire in middle, insert your favorite 3cond shielded cable in between, match colors at both ends, splice, done.
|
|
OP | Post 3 made on Tuesday April 21, 2015 at 21:29 |
mitsu Long Time Member |
Joined: Posts: | March 2003 105 |
|
|
yes that would work except I don't have any.
You mentioned 3 conductor. Where does the third conductor go?
|
|
OP | Post 4 made on Monday April 27, 2015 at 17:39 |
mitsu Long Time Member |
Joined: Posts: | March 2003 105 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.