Post 1 made on Wednesday March 18, 2015 at 10:27 |
hummer5 Long Time Member |
Joined: Posts: | March 2011 31 |
|
|
Hi all,
I had mrf350 which died on me over the weekend and I had a msc400 which i never got a chance to work on. Since mrf is gone i thought of programming it. I did setup macros on/off/watch. I also did the video sensing for 3 equipments. After i uploaded the file to 400 units, 4 lights( green) for video sensing are coming on. I have checked in my settings and only 3 equipments are using video sensing. No wire is infact going into the 4th port where the light is on. I have programmed the remote too but, seems like it is not working at all for me. I can see blue light on msc400 blinking when i press button on mx 980 but no response after that. I will appreciate help and or advise. I can upload my setup file to look at if some one has time to look at.
Thank you in advance guys.
Hummer
|
|
Post 2 made on Wednesday March 18, 2015 at 16:03 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,299 |
|
|
Sounds like the msc400 locked up. Have you tried recycling power to it?Try loading a blank file to it, then load your project file.
|
|
|
Post 3 made on Wednesday March 18, 2015 at 18:48 |
Lowhz Senior Member |
Joined: Posts: | April 2012 1,168 |
|
|
There's a reset button on the bottom of the chassis. Power cycle it while holding the button down for 30 seconds.
|
|
OP | Post 4 made on Thursday March 19, 2015 at 07:36 |
hummer5 Long Time Member |
Joined: Posts: | March 2011 31 |
|
|
Thank you so much guys,seems like the resetting fixed the issue.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.