Post 1 made on Wednesday January 21, 2015 at 08:27 |
Since there is no forum for Total Control I'm trying it here. Has anyone successfully commpunicated with a Sony VPL-HW50ES using RS-232? I have it defined in Accelerator, port 1, 9600 baud, 8 data, no parity, 1 stop bit. The auto gen macro created a power on, pause, and then another power on. I thought this was strange, but even with 1 power on it doesn't work. Any ideas?
|
|
Post 2 made on Wednesday January 21, 2015 at 10:48 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,298 |
|
|
|
Post 3 made on Wednesday January 21, 2015 at 14:26 |
Lowhz Senior Member |
Joined: Posts: | April 2012 1,168 |
|
|
Communication protocol for the VPLHW50ES says 38.4 kbps, 8 data bits, 1 stop bit.
That projector needs 2 power on commands to wake from low state and turn on.
Looking in the URC drivers I don't think those are the right commands.
Power on should be 0xA9 0x2E 0x00 0x00 0xAF 0x9A Power off should be 0xA9 0x2F 0x00 0x00 0xAF 0x9A
Try that.
|
|
Post 4 made on Wednesday January 21, 2015 at 17:30 |
thxext Long Time Member |
Joined: Posts: | December 2005 50 |
|
|
Don't forget your null modem adapter. :)
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.