| Post 1 made on Thursday December 25, 2014 at 19:19 |
Diamond Dog Long Time Member |
|
|
I have a MX-980. Bought a new TV and went from a Sony to a Samsung.
In CCP I replaced the old TV codes with the IR Database and saved.
Everything works fine and all functions on the TV work great. If I create a button on another device referencing the TV on and Off buttons, those work fine too. For example:
ALIAS [TV Only/power on]
however I have a macro to turn on my preamp to internet radio and turn the TV on too and it won't turn the TV on even though it is referencing the same location as above. I can not figure this out. The just recorded my steps in the Macro window. Currently it says:
ALIAS [TV Only/power on]
DELAY [1.0 seconds]
ALIAS [Preamp/power on]
DELAY [1.0 seconds]
ALIAS [Preamp/Page1/Net Audio]
DELAY [1.0 seconds]
ALIAS [TV only/Page1/HDMI1]
TV is running off MRF-350 on port #5 and the Preamp is on port#1
I have the same macro with a media streamer and the TV will not come on, but it works when I do it through the actual TV device.
What am I doing wrong?
|
|
| OP | Post 2 made on Thursday December 25, 2014 at 19:35 |
Diamond Dog Long Time Member |
|
|
Figured it out. Those keys were set to "punch through" so the punch through takes priority over running the macro. The macro doesnt run if it is set to punch through
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
