On December 13, 2014 at 13:52, Lowhz said...
Load the same program into it with a current CCP build. The firmware gets updated first and then the program transfers.
That's the problem. I don't have the program that's loaded in saved anywhere. I need to read it in and save it first. But I'm getting an error message at about 80%. This happened on both of the keypads (both had the same programming before I overwrote the first). Once I overwrote with a new file, now I have no problem reading or writing files, so the firmware upgrade must have made it work.
I suppose I could load up an older version of CCP and see it it reads the old program from the second keypad.
I just thought there was a way to update the firmware without overwriting (or writing) a program file.