Post 1 made on Friday July 11, 2014 at 12:01 |
drummerdude Lurking Member |
|
|
I am trying to program my dads mx-780 and I have the main programed, easiest for me was to use the function view, I decided that main 1 would be activity macros and supporting pages, and main 2 would be devices and supporting pages. in the function view in ccp I can only get to main 1, I can't figure out how to get to main 2. the only way I was able to get to devices was by adding them and opening the macro from main 1 in function view, but like I said I can't get to main 2. any help would be appreciated... I miss the mx-900 stand alone software, I feel like I could do way more and had way more control than using CCP, glad I didn't start off using CCP. thanks
|
|
OP | Post 2 made on Friday July 11, 2014 at 14:03 |
drummerdude Lurking Member |
|
|
figured it out, double click the page label under the main 2 heading. must have been tired last night not to figure that one out.
|
|
Post 3 made on Friday July 11, 2014 at 17:28 |
cb1 Select Member |
Joined: Posts: | September 2002 1,663 |
|
|
I would just put them on the main 1 pages and hide main 2 unless your using it for a second zone
|
why have a nice system if you cant operate it, program the remote the right way the FIRST time! |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.