Post 1 made on Tuesday January 28, 2014 at 19:18 |
tonydutt Lurking Member |
Joined: Posts: | January 2014 5 |
|
|
I am interested in programming my AudioControl Director D3200 to be able to select which rooms I want either Local, Bus 1 or Bus 2 to go to using TelNet commands to change the D3200 settings. I can program CCP to just about anything, but, I can't figure out how to initiate a TelNet session and issue these commands.
Does anyone know if it is possible or does anyone have a better idea how to control the D3200 through CCP and iOS?
MRX-1, MX-980, Iphone and Ipad control of lights and A/V throughout the house.
Thanks!!!!!
|
|
OP | Post 2 made on Saturday February 8, 2014 at 17:13 |
tonydutt Lurking Member |
Joined: Posts: | January 2014 5 |
|
|
Ok.... So, this was a very easy fix. 1. CCP is capable of sending the telnet commands via IP. Or, better said, IP handles telnet protocol commands as the D3200 does not require a log in.
2. The problem is D3200 is not part of the command set for IP in the latest update of CCP. However, you can easily reprogram any other command set to the ASCII characters you want. But, CCP does not save the new commands. Every time you want to use them, you have to retype them in. Does anyone know how to add a command set?
I have another post on this topic for variable usage for a multi-zone amp with three source selects.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.