Post 1 made on Sunday December 29, 2013 at 00:05 |
dalto Long Time Member |
Joined: Posts: | July 2005 435 |
|
|
I have a strange with an MX-1200 I just reprogrammed.
The receiver connects to an MSC-400 using the serial port.
The receiver device itself works fine. All the buttons do what they should.
However, no aliases to this device work at all. Also, if I punch through to that device it also doesn't work.
Has anyone seen this before? Any ideas?
|
|
Post 2 made on Sunday December 29, 2013 at 02:52 |
tinsnow Long Time Member |
Joined: Posts: | February 2013 131 |
|
|
Do you have variables in the macro you are running.?
If yes, see below thread for "Variables not working". This is an identified bug.
|
|
OP | Post 3 made on Monday December 30, 2013 at 16:51 |
dalto Long Time Member |
Joined: Posts: | July 2005 435 |
|
|
My variables are working fine. It fails even just with the punched through commands to that device.
|
|
Post 4 made on Tuesday December 31, 2013 at 04:32 |
tinsnow Long Time Member |
Joined: Posts: | February 2013 131 |
|
|
By the way, there is also a Punch Through bug from a long time that URC did not fix. ha ha.
I posted again and you should see the other post.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.