Post 1 made on Saturday November 2, 2013 at 11:37 |
smwinegard Lurking Member |
Joined: Posts: | February 2013 1 |
|
|
I have been trying to the code set that I found on both CCP and MX-900 editors and there are only two listings. I tried learning the codes, and that was even a bigger mistake. Guide becomes Previous channel for about 4 out of 5 times. Tried adjusting time holding button, and still no change. Most number buttons and the up arrow and down arrows for the actual code set send at least two presses even if I learn the set into the remote. Any ideas? This is for a customer that his hi-rise has gone to this hotel style setup. For right now I have to have him on MX-900 for everything else and then his piece of junk Time Warner remote.
|
smwinegard |
|
Post 2 made on Monday November 4, 2013 at 18:06 |
KVH Advanced Member |
Joined: Posts: | December 2006 911 |
|
|
I ran into this same issue here.... condo went from Charter to this ADB crap.... and that's what it is. We emailed ADB about trying to get codes to work and I'll paraphrase here but they essentially said "you cannot use any other remote other than the OEM, and we did this on purpose."
The best I could do to get anything close to work (MX880 and MRF 350) is to learn the codes from the OEM remote like it is a toggle bit remote, even though it is not. You will learn each code twice into the MX900.
Hope this helps.
|
All high's, all low's, it must be....... Einstein @ URC Control Room forum www.einsteinaudiosystems.com |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.