| Post 1 made on Tuesday October 15, 2013 at 16:55 |
hello all,
So I was just wondering if anyone could point me in the direction to some literature or videos on pairing rf bases and maybe some overview on the computer programmable urc remotes. I'm trying to stay sharp and brush up a bit before I start at a new av company and I'm used to mostly higher end automation remotes. Been a while since I've had to use an mrf-350 or 260 and I'm just looking for some info to brush up. Thanks for the assist!!!
|
|
| Post 2 made on Wednesday October 16, 2013 at 08:33 |
Duct Tape Loyal Member |
Joined:
Posts: | November 2008
5,298 |
|
|
the MRF350 and MRF260 don't get paired. by that, i mean that you don't plug them into a computer for programming. you just set the RFID dial on them to match the remote that was programmed.
if you have a copy of Complete Control Program (CCP), most of the programming and install manuals are available in the help tab of the software. the online training courses are only available through the URCcontrolroom website, which is dealer only.
|
|
|
| OP | Post 3 made on Wednesday October 16, 2013 at 13:07 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
