|
|
|
Complete Control by URC Forum - View Post
|
|
|
|
|
|
|
The following page was printed from RemoteCentral.com:
MX950 - Only works when in the charging...
| |
|
Topic: | MX950 - Only works when in the charging cradle This thread has 9 replies. Displaying all posts. |
|
Post 1 made on Wednesday September 4, 2013 at 06:44 |
riggy69 Lurking Member |
Joined: Posts: | September 2013 3 |
|
|
I have been happily using an MX950 for a good few years now. However, a few weeks ago I accidentally dropped the remote after which it would function only when in the charging cradle. I have managed to find a replacement remote on eBay which arrived today. I've programmed it OK with my saved copy of the software and all seemed OK for a while. But after an hour or so that too is now behaving in exactly the same way as me original damaged one. When the remote is in the cradle the blue status light is illuminated, but when I remove it from the cradle, the remote(s) just goes dead. Does anyone have any suggestions on this strange problem?
|
|
Post 2 made on Wednesday September 4, 2013 at 06:52 |
goldenzrule Loyal Member |
Joined: Posts: | July 2007 8,474 |
|
|
|
Post 3 made on Wednesday September 4, 2013 at 07:52 |
kdp99 Long Time Member |
Joined: Posts: | April 2004 143 |
|
|
On September 4, 2013 at 06:52, goldenzrule said...
Try a new battery? Agree 100%, I had exactly this problem, got a new battery from Germany for £5 in a few days, and all is well.
|
|
OP | Post 4 made on Wednesday September 4, 2013 at 11:13 |
riggy69 Lurking Member |
Joined: Posts: | September 2013 3 |
|
|
Thanks goldenzrule and kdp99, but I have tried a new battery with no luck. With the new battery installed, the status light just goes straight to blue suggesting its fully charged - and that's the same on the two cradles I now have.
|
|
Post 5 made on Wednesday September 4, 2013 at 12:23 |
goldenzrule Loyal Member |
Joined: Posts: | July 2007 8,474 |
|
|
Where did you get the new battery? Did it come with the newer remote?
|
|
Post 6 made on Wednesday September 4, 2013 at 13:02 |
Control Remotes Super Member |
Joined: Posts: | August 2003 3,434 |
|
|
Did you call URC about replacing it? They offer replacements for FAR less than retail and probably less than "new" on eBay. Just FYI.
Damon
|
Remote Programming Services for URC Remotes http://www.PremierAVDesigns.com - 914-509-5360 Follow me on Twitter @HomeTheaterNY |
|
Post 7 made on Saturday September 7, 2013 at 10:54 |
Tom Ciaramitaro Loyal Member |
Joined: Posts: | May 2002 7,965 |
|
|
In order of likelihood:
1. Bad battery 2. Broken pc traces on board where battery plugs in (battery change can do this) 3. Oxidation of charging contacts on wand or dock. Use fiberglass brush or soft pencil eraser to scrub/shine up both sets of contacts 4. Defective remote 5. User malfunction
Last one is for fun.
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
Post 8 made on Thursday September 12, 2013 at 10:30 |
It is quite possible that the replacement battery that you purchased is defective. I would try returning/exchanging it for a new one before replacing the remote or sending it in for repair. Also I would make sure that the battery contacts nice and clean.
|
|
|
OP | Post 9 made on Monday September 16, 2013 at 14:14 |
riggy69 Lurking Member |
Joined: Posts: | September 2013 3 |
|
|
thanks to everyone for the helpful replies. I got another new battery and sure enough that did the trick!
|
|
Post 10 made on Monday September 16, 2013 at 21:43 |
Ernie Gilman Yes, That Ernie! |
Joined: Posts: | December 2001 30,104 |
|
|
Just some possible insight -- a battery can "look" like a good battery to the charger, yet not be able to output enough current when out of the charger to run the remote. In that case the charger is running the remote. As said, poor contacts can cause this, but also a battery that's defective inside.
|
A good answer is easier with a clear question giving the make and model of everything. "The biggest problem in communication is the illusion that it has taken place." -- G. “Bernie” Shaw |
|
|
Before you can reply to a message... |
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now. |
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
|
|
|
|