Post 1 made on Saturday July 20, 2013 at 23:05 |
OneRemote Long Time Member |
|
|
Just bought a MX-780 for a bonus room in the house and got a MRF-350 with it. In CCP I've set each activity and device to do both RF+IR and assigned them to the MRF-350 as the base station. The emitter output for each device is set to ALL versus a single emitter port or blaster only.
The blaster doesn't seem to turn anything on, even if I hold it directly in front of the devices. The emitters connected to the back of the MRF-350 work and do control my devices but for some reason the main blaster in the MRF-350 doesn't seem to work.
Defective unit, or am I doing something wrong?
Thanks!
|
|
Post 2 made on Sunday July 21, 2013 at 01:03 |
Lowhz Senior Member |
Joined: Posts: | April 2012 1,168 |
|
|
"all" means all emitter outputs. You need to set each device to blaster in CCP.
|
|
OP | Post 3 made on Sunday July 21, 2013 at 01:07 |
OneRemote Long Time Member |
|
|
|
Post 4 made on Sunday April 24, 2016 at 16:28 |
Jottle Long Time Member |
Joined: Posts: | November 2006 96 |
|
|
I have an mx-810 and an mrf-260. I want to use just the front blaster of my 260 (no flashers), but I noticed that there's no option to assign devices to the blaster on the prowizard software. So I'm assuming the blaster is always on for all devices unless I go into prowizard and manually disable it, correct? I don't see any way to specifically select the blaster, just flashers 1, 2, 3, etc. So is there anything I need to do if I want to use just the front ir blaster in my setup w/out the flashers? I was going to set all the devices to RF only.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.