Post 1 made on Wednesday July 3, 2013 at 20:12 |
Diamond Dog Long Time Member |
|
|
In CCP you can not select a MRF-250 base station. Or can you?
I select the mrf-260 which works, but that only allows you to have 4 IR ports out.
I need 5 and my MRF-260 has 6.
Would just select "all" solve the problem or is there a better way? Are there any downsides from selecting "all" for sending a signal through all the ports?
|
|
Post 2 made on Wednesday July 3, 2013 at 20:41 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,298 |
|
|
Just use an mrf350 in your programming and ignore the 6th port.
selecting all usually doesnt hurt unless you have two or more pieces of equipment that use the same code.
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.