Post 1 made on Thursday June 13, 2013 at 01:49 |
I have an MX900 that recently started only working when I point it directly at the MRF-260 base station. I've confirmed in the Editor that my Receiver is set to ID1 and the MRF-260 is also set to 1. Any suggestions? Thanks.
|
|
Post 2 made on Thursday June 13, 2013 at 03:38 |
Daniel Tonks Wrangler of Remotes |
Joined: Posts: | October 1998 28,780 |
|
|
Added anything new lately? Could be RF noise. Try moving the MRF-260 to another location, even a few feet away, and see if the situation changes.
|
|
Post 3 made on Thursday June 13, 2013 at 08:51 |
FP Crazy Super Member |
Joined: Posts: | June 2003 2,940 |
|
|
Or set the MRF-260 to 0 (not the remote) and start pressing buttons on the remote. Watch the activity LED on the 260. It will flicker when you press a button on the remote. If it still flickers after you quit pressing buttons on the remote, then you have interference and will need to play around with different locations. possibly even remove the antenna on the 260 to see if that helps.
|
Chasing Ernie's post count, one useless post at a time. |
|
Post 4 made on Thursday June 13, 2013 at 08:53 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,299 |
|
|
did you change each device from IR to RF in your RF setup menu?
|
|
|
Post 5 made on Thursday June 13, 2013 at 09:58 |
JoeFlabitz Select Member |
Joined: Posts: | December 2008 1,517 |
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.