Just got my MX-780 and MRF-260 setup and programmed and everything is working great except for macros. I have macros setup to turn everything on and set inputs. in the transporter page i drag the power on command to my macro. Everything looks fine, but the command only works line of sight/ IR in the macro. if i click the receiver on the remote then all the commands go through RF. I cant seem to figure out how to get it to send the Commands through RF in the Macros. It only sends commands in macros through IR.

Ok I figured it out. Not sure if its because the macro button was on the main screen or just because that's the way it works, but I had to set main to RF/IR and now everything works.

There is always Macro icon on the device key, even if you didn't enable it. It uses macro to jump to the first page of the device.

Aside from setting your Main page to IR/RF have you also assigned your source pages properly in the base station?
Also, i'm assuming your Macros are not created by Aliasing buttons which is why you had to set up your Main page for IR/RF?