Post 1 made on Tuesday October 30, 2012 at 13:01 |
Got a call from a client that just swapped out his 3 year old Direc TV receiver. They swapped it out with the HR34-700 unit which is the new Genie system. Haven't seen it yet but before walking in wanted to have the remote programmed and ready to go. Updated the database in CCP and don't see the remote listed. Has anyone done one of these units or found a code set to work with it yet?
Thanks,
Pat
|
Pat M |
|
Post 2 made on Tuesday October 30, 2012 at 19:22 |
KVH Advanced Member |
Joined: Posts: | December 2006 911 |
|
|
|
OP | Post 3 made on Wednesday October 31, 2012 at 10:47 |
So then it should be the same code set that I already used. Now to make a try and figure out why it doesn't work. Thanks for the info.
|
Pat M |
|
Post 4 made on Wednesday October 31, 2012 at 14:39 |
tweeterguy Loyal Member |
Joined: Posts: | June 2005 7,713 |
|
|
Do you have an MRF or MSC (or any IR repeater for that matter) installed? If yes, then my money is on the IR emitter being in the wrong place or completely removed.
|
|
Post 5 made on Wednesday October 31, 2012 at 17:57 |
Duct Tape Loyal Member |
Joined: Posts: | November 2008 5,295 |
|
|
Is the receiver set for ir and not rf?
|
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.